Abstract

Experimental investigations were conducted for the internal flows of the axial flow stator and diagonal flow rotor. Corner separation near the hub surface and the suction surface of stator blade are mainly focused on. For the design flow rate, the values of the axial velocity and the total pressure at stator outlet decrease between near the suction surface and near the hub surface by the influence of corner wall. For the flow rate of 80-90% of the design flow rate, the corner separation of the stator between the suction surface and the hub surface is observed, which becomes widely spread for 80% of the design flow rate. At rotor outlet for 81% of the design flow rate, the low axial velocity region grows between near the suction surface of rotor and the casing surface because of the tip leakage flow of the rotor.

주제어

#Axial flow stator   #Diagonal flow rotor   #Internal flow   #Corner separation  

저자의 다른 논문

참고문헌 (5)

1. Joslyn H.D. and Dring R., 1985, “Axial Compressor Stator Aerodynamics,” ASME Journal of Engineering for Gas Turbines and Power Trans. ASME, Vol. 107, pp. 485-493. 
2. Dong Y., Gallimore S.J. and Hodoson H.P., 1987, “Three-Dimensional Flows and Loss Reduction in Axial Compressors,“ Journal of Turbomachinery Trans. ASME, Vol. 109, pp. 354-361. 
3. Schlz H.D. and Gallus H.D., 1988, “Experimental Investigation of the Three-Dimensional Flow in Annular Compressor Cascade,” Journal of Turbomachinery Trans. ASME, Vol. 110, pp. 467-478. 
4. Hah C. and Loellbach J., 1999, “Development of Hub Corner Stall and Its Influence on the Performance of Axial Compressor Blade Rows”, Journal of Turbomachinery Trans. ASME, Vol. 121, pp. 67-77. 
5. Kuroumaru, M., Inoue, M., Higaki, T., Abd-elaziz, F. A. and Ikui, T., 1982, “Measurement of Three-Dimensional Flow Field behind an Impeller by Means of Periodic Multi-Sampling of a Slanted Hot Wire,” Bulletin of the JSME, Vol. 25, No. 209, pp. 1674-1681. 

이 논문을 인용한 문헌 (0)

1. 이 논문을 인용한 문헌 없음