국내 수질기준은 목표수질 달성을 위하여 계속 강화되고 있다. 이를 달성하기 위하여 하수처리장의 효율 향상과 CSO와 SSOs 저감을 위하여 하수관거 정비사업을 진행하고 있다. 또한 하수관거정비사업의 평가지표 중 하나로 I/I를 사용하고 있는데, 여러 가지 분석방법 중 BOD5 부하량을 이용한 분석법은 평균 유량과 기저유량의 BOD5를 측정하여 희석정도를 평가하는 방법이다. 본 연구에서는 현장 측정이 가능한 ...
국내 수질기준은 목표수질 달성을 위하여 계속 강화되고 있다. 이를 달성하기 위하여 하수처리장의 효율 향상과 CSO와 SSOs 저감을 위하여 하수관거 정비사업을 진행하고 있다. 또한 하수관거정비사업의 평가지표 중 하나로 I/I를 사용하고 있는데, 여러 가지 분석방법 중 BOD5 부하량을 이용한 분석법은 평균 유량과 기저유량의 BOD5를 측정하여 희석정도를 평가하는 방법이다. 본 연구에서는 현장 측정이 가능한 전기전도도가 BOD5 대신를 대신하여 적용 가능성이 있는지에 대한 상관성을 분석하였다. 적용대상지는 경기도 J 택지개발지구의 하수관거와 서울시 S-STP 방류수를 대상으로 수행하였다.
경기도 J 택지개발지구내 하수관거에서 수질을 측정하여 전기전도도와 BOD의 상관성 분석 결과 BOD5 (mg/L)= 0.1862 × Electrical Conductivity(㎲/㎝)로 R2는 0.9337로 계산되었다. 하수관거내 현장시료 48개의 전기전도도와 BOD5, TN, 그리고 TP와의 관계를 분석한 결과 R2는 0.8471, 0.6553 그리고 0.6525로 분석되었었다.
J 택지개발 지구의 하수 유량 및 I/I 평가결과 조사기간 3월 6일부터 4월 13일까지 40여 일간 하수배수구역 기준으로 4개 Site를 측정한 결과 일평균유량은 11,144 ㎥/d, 일최대유량은 12,567 ㎥/d로 측정되었으며 I/I량은 상수사용량에 의한 평가시 602 ㎥/d, BOD 부하량에 의한 평가시 208 ㎥/d, 일최저유량에 의한 평가시 1,712 ㎥/d였고, 본 연구에서 제안하는 EC 부하량을 이용한 방법으로는 321 ㎥/d 로 분석되었다.
이 결과를 하수방류수역에서 혼합특성을 분석하기 위하여 S-STP 방류수 수역에서 하수방류수와 한강수를 혼합한 결과 BOD5 (mg/L)= 0.018 × 전기전도도로(㎲/㎝)로 R2는 0.8986으로 높게 나타났다. 뿐만 아니라 이때 측정된 TN, TP도 전기전도도와의 R2가 0.8397과 0.9474로 비교적 높은 상관성을 가졌다. 전기전도도와 BOD5 관계식으로부터 상관성 확인 후 현장에서 하수 혼합특성 평가시 전기전도도의 적용 가능성을 제안하였다.
국내 수질기준은 목표수질 달성을 위하여 계속 강화되고 있다. 이를 달성하기 위하여 하수처리장의 효율 향상과 CSO와 SSOs 저감을 위하여 하수관거 정비사업을 진행하고 있다. 또한 하수관거정비사업의 평가지표 중 하나로 I/I를 사용하고 있는데, 여러 가지 분석방법 중 BOD5 부하량을 이용한 분석법은 평균 유량과 기저유량의 BOD5를 측정하여 희석정도를 평가하는 방법이다. 본 연구에서는 현장 측정이 가능한 전기전도도가 BOD5 대신를 대신하여 적용 가능성이 있는지에 대한 상관성을 분석하였다. 적용대상지는 경기도 J 택지개발지구의 하수관거와 서울시 S-STP 방류수를 대상으로 수행하였다.
경기도 J 택지개발지구내 하수관거에서 수질을 측정하여 전기전도도와 BOD의 상관성 분석 결과 BOD5 (mg/L)= 0.1862 × Electrical Conductivity(㎲/㎝)로 R2는 0.9337로 계산되었다. 하수관거내 현장시료 48개의 전기전도도와 BOD5, TN, 그리고 TP와의 관계를 분석한 결과 R2는 0.8471, 0.6553 그리고 0.6525로 분석되었었다.
J 택지개발 지구의 하수 유량 및 I/I 평가결과 조사기간 3월 6일부터 4월 13일까지 40여 일간 하수배수구역 기준으로 4개 Site를 측정한 결과 일평균유량은 11,144 ㎥/d, 일최대유량은 12,567 ㎥/d로 측정되었으며 I/I량은 상수사용량에 의한 평가시 602 ㎥/d, BOD 부하량에 의한 평가시 208 ㎥/d, 일최저유량에 의한 평가시 1,712 ㎥/d였고, 본 연구에서 제안하는 EC 부하량을 이용한 방법으로는 321 ㎥/d 로 분석되었다.
이 결과를 하수방류수역에서 혼합특성을 분석하기 위하여 S-STP 방류수 수역에서 하수방류수와 한강수를 혼합한 결과 BOD5 (mg/L)= 0.018 × 전기전도도로(㎲/㎝)로 R2는 0.8986으로 높게 나타났다. 뿐만 아니라 이때 측정된 TN, TP도 전기전도도와의 R2가 0.8397과 0.9474로 비교적 높은 상관성을 가졌다. 전기전도도와 BOD5 관계식으로부터 상관성 확인 후 현장에서 하수 혼합특성 평가시 전기전도도의 적용 가능성을 제안하였다.
Evaluation on I/I and Mixed Characteristics of Sewage using Data of Electrical Conductivity
By Kong, Sung-Ho
Department of Environmental Enginering
Graduate School od Urban Science
The University of Seoul
Supervised by Professor Park, Chul-Hwi
Abstract
Ministry of environment has strengt...
Evaluation on I/I and Mixed Characteristics of Sewage using Data of Electrical Conductivity
By Kong, Sung-Ho
Department of Environmental Enginering
Graduate School od Urban Science
The University of Seoul
Supervised by Professor Park, Chul-Hwi
Abstract
Ministry of environment has strengthened water quality standards for achieving water quality goals continuously. Sewer rehabilitation project is progressing for improvement of efficiency in sewage treatment plant(STP) and reduction of CSOs and SSOs.
Infiltration/Inflow (I/I) is used for one of the evaluation indicators of this project and, methodology using BOD5 is the evaluation method for dilution level with measurement of BOD5 loading of the average daily flow and minimum daily flow. Evaluation on I/I of sewage treatment plant and mixed characteristics of sewage in J-Residential Development District of Gyeonggi-do, and mixed characteristics of Han-River in S-STP effluent watershed conducted.
The result of analysis for correlation of electrical conductivity(EC) and BOD on water quality measurement from sewer system in J-Residential Development District of Gyeonggi-do is as follows : BOD5 (mg/L)= 0.1862 × EC(㎲/㎝), determination (R2) is 0.9337. And among EC, BOD5, TN, and TP from 48 samples in sewer system show that each of determination (R2) of the analysis item and EC is 0.8471, 0.6553 and 0.6525.
According to sewage flow from Mar. 6 to Apr. 13 for 40days in J-Residential Development District of Gyeonggi-do, average daily flow is 11,144 ㎥/d and maximum daily flow is 12,567 ㎥/d. I/I was analyzed 602 ㎥/d by water-use evaluation, 208 ㎥/d by average-minimum daily flow quality evaluation and 1,712 ㎥/d by minimum daily flowrate evaluation. And this study result was 321 ㎥/d by average-minimum daily flow quality(EC) evaluation.
The results of mixed characteristics of S-STP effluent and Han-River indicated BOD5 (mg/L) = 0.018 × EC(㎲/㎝) and R2 was significantly higher than 0.8986. In addition, R2 of EC and TN, TP was relatively high 0.8397 and 0.9474.
Therefore, EC were likely to show that determined to be an alternative measurement method of BOD5 for I/I evaluation and sewage mixing characteristics in sewer system and watershed.
Key words : EC, Infiltration/Inflow, BOD, Sewer, Effluent, Water Quality
Evaluation on I/I and Mixed Characteristics of Sewage using Data of Electrical Conductivity
By Kong, Sung-Ho
Department of Environmental Enginering
Graduate School od Urban Science
The University of Seoul
Supervised by Professor Park, Chul-Hwi
Abstract
Ministry of environment has strengthened water quality standards for achieving water quality goals continuously. Sewer rehabilitation project is progressing for improvement of efficiency in sewage treatment plant(STP) and reduction of CSOs and SSOs.
Infiltration/Inflow (I/I) is used for one of the evaluation indicators of this project and, methodology using BOD5 is the evaluation method for dilution level with measurement of BOD5 loading of the average daily flow and minimum daily flow. Evaluation on I/I of sewage treatment plant and mixed characteristics of sewage in J-Residential Development District of Gyeonggi-do, and mixed characteristics of Han-River in S-STP effluent watershed conducted.
The result of analysis for correlation of electrical conductivity(EC) and BOD on water quality measurement from sewer system in J-Residential Development District of Gyeonggi-do is as follows : BOD5 (mg/L)= 0.1862 × EC(㎲/㎝), determination (R2) is 0.9337. And among EC, BOD5, TN, and TP from 48 samples in sewer system show that each of determination (R2) of the analysis item and EC is 0.8471, 0.6553 and 0.6525.
According to sewage flow from Mar. 6 to Apr. 13 for 40days in J-Residential Development District of Gyeonggi-do, average daily flow is 11,144 ㎥/d and maximum daily flow is 12,567 ㎥/d. I/I was analyzed 602 ㎥/d by water-use evaluation, 208 ㎥/d by average-minimum daily flow quality evaluation and 1,712 ㎥/d by minimum daily flowrate evaluation. And this study result was 321 ㎥/d by average-minimum daily flow quality(EC) evaluation.
The results of mixed characteristics of S-STP effluent and Han-River indicated BOD5 (mg/L) = 0.018 × EC(㎲/㎝) and R2 was significantly higher than 0.8986. In addition, R2 of EC and TN, TP was relatively high 0.8397 and 0.9474.
Therefore, EC were likely to show that determined to be an alternative measurement method of BOD5 for I/I evaluation and sewage mixing characteristics in sewer system and watershed.
Key words : EC, Infiltration/Inflow, BOD, Sewer, Effluent, Water Quality
※ AI-Helper는 부적절한 답변을 할 수 있습니다.