최소 단어 이상 선택하여야 합니다.
최대 10 단어까지만 선택 가능합니다.
다음과 같은 기능을 한번의 로그인으로 사용 할 수 있습니다.
NTIS 바로가기전기학회논문지 = The Transactions of the Korean Institute of Electrical Engineers, v.65 no.6, 2016년, pp.955 - 961
이경민 (Dept. of Electrical Engineering, Gangneung-Wonju National University) , 박철원 (Dept. of Electrical Engineering, Gangneung-Wonju National University)
Fault location estimation is an important element for rapid recovery of power system when fault occur in transmission line. In order to calculate line impedance, most of fault location algorithm uses by measuring relaying waveform using DFT. So if there is a calculation error due to the influence of...
* AI 자동 식별 결과로 적합하지 않은 문장이 있을 수 있으니, 이용에 유의하시기 바랍니다.
핵심어 | 질문 | 논문에서 추출한 답변 |
---|---|---|
직류옵셋제거필터는 어떻게 직류옵셋성분을 결정하는가? | 직류옵셋제거필터는 고조파성분을 점차적으로 소거하여 직류 옵셋성분만 남게 하여 고장신호에 포함된 직류옵셋성분을 결정하게 된다. 이후 고장신호에서 직류옵셋성분을 제거하여 필터링을 수행한다. | |
IED나 디지털 고장점표정장치는 어떻게 고장을 탐지하는가? | 그런데 대부분의 IED(Intelligent Electronic Device)나 디지털 고장점표정장치는 왜곡된 계전신호로부터 원하는 성분만 추출하는 기법을 탑재하여 운영하게 된다. 이 장치는 설치점에서 바라보 는 임피던스를 이용하여 사고를 판단하거나 고장점을 추정한다. 이때 고조파 및 직류옵셋의 영향으로 페이저연산시 오차가 발생 하는 경우, 계산된 임피던스에 과도진동이 발생하여 오버리치(overreach) 또는 언더리치(underreach)에 따라 IED나 고장점표 정장치가 오동작이나 부동작을 발생할 수 있다. | |
송전선로에서 사고가 발생함을 어떻게 알 수 있는가? | 만약 디지털 고장점표정장치(fault locator)가 없다면 넓은 지역에 분포되어 있 는 송전선로 구간에서 고장점을 찾는데 많은 인력과 시간이 소모 될 것이다. 한편, 송전선로에서 사고가 발생하게 되면 전압 및 전류 등의 계전신호는 고조파성분과 직류옵셋성분(DC offset component)으로 심하게 찌그러진다. 특히 직류옵셋성분은 전압 사고각이 0°, 180° 부근에서 현저하게 포함되며 지수함수 형태로 감소한다[2]. |
IEEE Tutorial Course, "Advancements in Microprocessor based Protection and Communication", The Institute of Electrical and Electronics Engineers Inc., pp. 63-72, 1997.
S. H. Horowitz, A.G. Phadke, "Power System Relaying", John Wiley & Sons, Ltd, RSP, pp. 1-331, 2008.
M. H. J. Bollen, "Traveling-wave-based protection of double-circuit", Proc. Inst. Elect. Eng., C, Vol. 140, No. 1, pt. C, pp. 37-47, 1993. 1.
G. B. Ancell and N. C. Pahalawaththa, "Maximum likelihood estimation of fault location on transmission lines using traveling waves", IEEE Trans. Power Delivery, Vol. 9, No. 2, pp. 680-689, 1994. 4.
S.H. Kang, J.K. Park, "A New Digital Distance Relaying Algorithm Based on Fast Haar Transformation Techniques with Half a Cycle Offset Free Data", Trans. KIEE, Vol. 41, No. 9, pp. 973-983, 1992. 9.
Y.J. Kwon, S.H. Kim, S.H. Kang, "Transmission Line Fault Location Algorithm Using Estimated Local Source Impedance", Trans. KIEE, Vol. 58. No. 5, pp. 885-890, 2009. 5.
J. Y. Heo, C.H. Kim, S.M. Yeo, "A Dynamic Simulation of Distance Relay Using EMTP MODELS", Trans. KIEE, Vol. 52A. No. 1, pp. 17-28, 2003. 1.
J.G. Lee, S.K. You, "The Real-Time Distance Relay Algorithm Using Fault Location Estimation Information for Parallel Transmission Line", Trans. KIEE, Vol. 52A. No. 3, pp. 183-192, 2003. 3.
S.H. Kang, J.H. Kim, "A Fault Location Algorithm for a Transmission Line Using Traveling Waves", Trans. KIEE, Vol. 53A, No. 10, pp. 542-549, 2004. 10.
M.S. Choi, S.J. Lee, S.I. Lee, B.G. Jin, D.S. Lee, "A New Line to Line Fault Location Algorithm in Distribution Power Networks using 3 Phase Direct Analysis", Trans. KIEE, Vol. 51A No. 9, pp. 467-473, 2004. 9.
D.G. Lee, S.H. Kang, "Distance Relaying Algorithm Using a DFT-based Modified Phasor Estimation Method", Trans. KIEE, Vol. 59, No. 8, pp. 1360-1365, 2010. 8.
H.S. Jung, B.K. Lee, C.W. Park, S.M. Yun, W.G. Jung, M.C. Shin, C.H. Kim, "A Neural Networks Fault Patterns Estimator for the Digital Distance Relaying Technique", Trans. KIEE, Vol. 47, No. 11, pp. 1804-18110, 1998. 11.
H.K. Park, J.G. Lee, S.K. You, "Fault Location Algorithm in Parallel Transmission Line Using Zero Sequence Network", KIEE Annual Conference, pp. 282-284, 1999. 11.
D.G. Lee, S.H. Kang, "Distance Relaying Algorithm Using a DFT-based Phasor Estimating Method", Trans. KIEE, Vol. 59, No. 8, pp. 1360-1365, 2010. 8.
S.H Hyun, B.G. Jin. S.J. Lee, "Agent-Based Distance Relay Algorithm for Phase-to Ground Faults", Trans. KIEE, Vol. 56, No. 11, pp. 1885-1891, 2007. 11.
Y.C. Kang, H.G. Kang, T.Y. Zheng, Y.H. Kim, Y.G. Lee, "Distance Relaying Algorithm for Intertie Protection of Wind Farm Considering the Fault Ride-through Requirement", Trans. KIEE, Vol. 59, No. 6, pp. 1053-1058, 2010. 6.
S.E. Noh, J.S. Kim, Y.G. Kim, J.C. Kim, S.H. Lim, "Analysis on Operational Characteristics of Distance Relay due to Application of Superconducting Fault Current Limiter in a Simulated Power Transmission Systems", Journal of KIIEE, Vol. 28, No. 8, pp. 40-46, 2014. 8.
K.K. Li, L.L. Lai, A.K. David, "Stand Alone Intelligent Distance Relay", IEEE Trans. on Power Systems, Vol. 15, No. 1, pp. 137-142, 2000. 2.
M. Singh, B.K. Panigrahi, A.R. Abhyankar, "Combined Optimal Distance to Overcurrent Relay Coordination", 2012 IEEE International Conference on Power Electronics, Drives and Energy Systems, Bengaluru, India, 978-1-4673-4508-8, pp. 1-6, 2012. 12.
M.H. Idris, M.S. Ahmad, A.Z. Abdullah, S. Hardi, "Adaptive Mho Type Distance Relaying Scheme with Fault Resistance Compensation", 2013 IEEE 7th International Power Engineering and Optimization Conference (PEOCO 2013), Langkawi, Malaysia NDICON), 978-1-4673-5074-7, pp. 213-217, 2013. 6.
J. Mooney, R. Cunico, "IEEE Guide for Determining Fault Location on AC Transmission and Distribution Lines", IEEE Standards Association, IEEE Std. C37.114, pp. 1-76, 2014.
C.W. Park, H.W. Yoon, "A Study on Accurate Phasor Extraction Using a New Offset Elimination Filter", Journal of KIIEE, Vol. 27, No. 7, pp. 29-36, 2013. 7.
C.W. Park, "Advanced DC Offset Removal Filter of High-order Configuration", Trans. KIEE, Vol. 62P, No. 1, pp. 12-17, 2013. 3.
*원문 PDF 파일 및 링크정보가 존재하지 않을 경우 KISTI DDS 시스템에서 제공하는 원문복사서비스를 사용할 수 있습니다.
※ AI-Helper는 부적절한 답변을 할 수 있습니다.