$\require{mediawiki-texvc}$

연합인증

연합인증 가입 기관의 연구자들은 소속기관의 인증정보(ID와 암호)를 이용해 다른 대학, 연구기관, 서비스 공급자의 다양한 온라인 자원과 연구 데이터를 이용할 수 있습니다.

이는 여행자가 자국에서 발행 받은 여권으로 세계 각국을 자유롭게 여행할 수 있는 것과 같습니다.

연합인증으로 이용이 가능한 서비스는 NTIS, DataON, Edison, Kafe, Webinar 등이 있습니다.

한번의 인증절차만으로 연합인증 가입 서비스에 추가 로그인 없이 이용이 가능합니다.

다만, 연합인증을 위해서는 최초 1회만 인증 절차가 필요합니다. (회원이 아닐 경우 회원 가입이 필요합니다.)

연합인증 절차는 다음과 같습니다.

최초이용시에는
ScienceON에 로그인 → 연합인증 서비스 접속 → 로그인 (본인 확인 또는 회원가입) → 서비스 이용

그 이후에는
ScienceON 로그인 → 연합인증 서비스 접속 → 서비스 이용

연합인증을 활용하시면 KISTI가 제공하는 다양한 서비스를 편리하게 이용하실 수 있습니다.

용액 퍼짐 상분리법을 통한 마이크로 기공 분리막 제조
Fabrication of Micro-Porous Membrane via a Solution Spreading Phase Inversion Method 원문보기

멤브레인 = Membrane Journal, v.29 no.2, 2019년, pp.105 - 110  

최욱 (인천대학교 기초과학연구소) ,  박철호 (한국에너지기술연구원 제주글로벌연구센터)

초록
AI-Helper 아이콘AI-Helper

다공성 분리막은 입자성 물질을 제거하는데 산업적으로 다양하게 응용되고 있다. 기존 다공성 분리막 제작 방법과 다르게, 용액퍼짐 상분리법은 매우 간단하게 기공을 형성할 수 있다. 먼저 지지층으로 메쉬 위에 물을 적신 후, 물과 혼합되지 않은 용매에 폴리설폰 용액을 흘려준다. 이때 물과 혼합되지 않은 용매는 쉽게 기화되어 폴리설폰은 얇은 막으로 만들어지게 된다. 기공을 형성하기 위해 폴리설폰 용액에 물과 혼합할 수 있는 물질을 넣게 되면, 넣어주는 농도 비율에 따라 기공크기를 조절할 수 있게 된다. 막의 두께는 쉽게 용액의 농도로 조절이 된다. 다공성 분리막은 메쉬의 형성을 그대로 유지하고 있어 3차원 구조체를 형성하는데 매우 유용하다. 본 연구에서 제시된 용액 퍼짐 상분리법은 매우 낮은 생산단가와 쉬운 공정조절에 의해 기존 분리막에 비해 높은 가격경쟁력을 가질 수 있는 특징을 보이고 있다.

Abstract AI-Helper 아이콘AI-Helper

Porous membranes are widely used in industry for removing particulate matter. Unlike conventional porous membrane fabrication methods, the solution spreading phase separation method can form pores very simply. The first step is to wet the mesh with the support layer, then to let the polysulfone solu...

주제어

AI 본문요약
AI-Helper 아이콘 AI-Helper

* AI 자동 식별 결과로 적합하지 않은 문장이 있을 수 있으니, 이용에 유의하시기 바랍니다.

문제 정의

  • However, until recently, there is no study about a solution spreading phase inversion method to fabricate the membrane. Therefore, this study exhibits that the suggested method is very unique to fabricate the MF membrane with satisfying all the needs.

가설 설정

  • The solution spreading is based on the solvent spreading on water. The solvent spreading must stratify two conditions; 1) the solvent should be buoyant in the subphase (water) without sinking and dissolving, 2) the solvent must spread on the surface of water. The solvent spreading is easily observed when the polymeric solutions were dropped on water.
본문요약 정보가 도움이 되었나요?

참고문헌 (16)

  1. L. R. Fukumoto, P. Delaquis, and B. Girard, “Microfiltration and ultrafiltration ceramic membranes for apple juice clarification”, J. Food Sci. , 65, 1 (1998). 

  2. 10.1016/j.lwt.2004.09.002 B. J. Wang, T. C. Wei, and Z. R. Yu, “Effect of operating temperature on component distribution of West Indian cherry juice in a microfiltration system”, LWT - Food Sci. Technol. , 35, 683 (2005). 

  3. 10.1016/j.fbp.2012.05.004 B. Razi, A. Aroujalian, and M. Fathizadeh, “Modeling of fouling layer deposition in cross-flow microfiltration during tomato juice clarification”, Food Bioprod. Process. , 90, 841 (2012). 

  4. J. Caro, “Basic principles of membrane technology”, Zeitschrift Fur Phys. Chemie. , 203, 1 (2011). 

  5. 10.1016/j.memsci.2013.04.009 M. Sadrzadeh and S. Bhattacharjee, “Rational design of phase inversion membranes by tailoring thermodynamics and kinetics of casting solution using polymer additives”, J. Memb. Sci. , 441, 31 (2013) doi: 10.1016/j.memsci.2013.04.009. 

  6. 10.1038/natrevmats.2016.18 J. R. Werber, C. O. Osuji, and M. Elimelech, “Materials for next-generation desalination and water purification membranes”, Nat. Rev. Mater. , 1, 16018 (2016) doi:10.1038/natrevmats.2016.18. 

  7. A. L. Zydney, Membrane handbook edited by W. S. Winston Ho, and Kamalesh K. Sirkar, “Van nostrand reinhold”, New York, 1992, 954 pp. 131.95, AIChE J. , 41, 954 (2004). 

  8. B. Wang, J. Ji, C. Chen, and K. Li, “Porous membranes prepared by a combined crystallisation and diffusion (CCD) method: Study on formation mechanisms”, J. Memb. Sci. , 548, 136 (2018). 

  9. 10.1016/j.cherd.2015.06.037 W. Choi, P. G. Ingole, J. S. Park, D. W. Lee, J. H. Kim, and H. K. Lee, “H2/CO mixture gas separation using composite hollow fiber membranes prepared by interfacial polymerization method”, Chem. Eng. Res. Des. , 102, 297 (2015). 

  10. 10.1016/j.microc.2017.01.001 W. Choi, P. G. Ingole, H. Li, S. Y. Park, J. H. Kim, H. K. Lee, and I. H. Baek, “Facilitated transport hollow fiber membrane prepared by t-Bu CoSalen for O2/N2 separation”, Microchem. J. , 132, 36 (2017). 

  11. 10.1016/j.memsci.2015.07.003 S. ichi Sawada, C. Ursino, F. Galiano, S. Simone, E. Drioli, and A. Figoli, “Effect of citrate-based non-toxic solvents on poly(vinylidene fluoride) membrane preparation via thermally induced phase separation”, J. Memb. Sci. , 493, 232 (2015). 

  12. 10.1016/j.memsci.2016.04.069 J. T. Jung, J. F. Kim, H. H. Wang, E. di Nicolo, E. Drioli, and Y. M. Lee, “Understanding the non-solvent induced phase separation (NIPS) effect during the fabrication of microporous PVDF membranes via thermally induced phase separation (TIPS)”, J. Memb. Sci. , 514, 250 (2016). 

  13. 10.1016/S0269-8579(89)80002-4 D. Mackay and C. D. McAuliffe, “Fate of hydrocarbons discharged at sea”, Oil Chem. Pollut. , 5, 1 (1989). 

  14. 10.1016/S0269-8579(88)80009-1 M. L. Spaulding, “A state-of-the-art review of oil spill trajectory and fate modeling”, Oil Chem. Pollut. , 4, 39 (1988). 

  15. 10.3390/polym6061846 H. Bin Li, W. Y. Shi, Y. F. Zhang, D. Q. Liu, and X. F. Liu, “Effects of additives on the morphology and performance of PPTA/PVDF in situ blend UF membrane”, Polymers. , 6, 1846 (2014). 

  16. M.-T. Lee, W.-C. Hung, F.-Y. Chen, and H. W. Huang, “Mechanism and kinetics of pore formation in membranes by water-soluble amphipathic peptides”, Acta Crystallogr. Sect. A Found. Crystallogr. , 64, 5087 (2015). 

저자의 다른 논문 :

섹션별 컨텐츠 바로가기

AI-Helper ※ AI-Helper는 오픈소스 모델을 사용합니다.

AI-Helper 아이콘
AI-Helper
안녕하세요, AI-Helper입니다. 좌측 "선택된 텍스트"에서 텍스트를 선택하여 요약, 번역, 용어설명을 실행하세요.
※ AI-Helper는 부적절한 답변을 할 수 있습니다.

선택된 텍스트

맨위로