[논문]발전소 공기예열기 소재의 배기가스 농도 및 온도에 따른 내식성 및 노점 분석

이승준

doi:10.14773/cst.2023.22.5.351

[국내논문] 발전소 공기예열기 소재의 배기가스 농도 및 온도에 따른 내식성 및 노점 분석
Analysis of Corrosion Resistance and Dew Point with Exhaust Gas Concentration and Temperature for Air Preheater Materials in Power Plants 원문보기

Corrosion science and technology, v.22 no.5, 2023년, pp.351 - 358

이승준 (군산대학교 ONSE대학 기관공학전공)

Abstract ▼ AI-Helper

Although many thermal power plants use heat recovery systems, high exhaust gas temperatures are maintained due to corrosion at dew points and ash deposits caused by condensate formation. The dew point of exhaust gas is primarily determined by the concentration of SO3 and steam, and various experiments and calculation equations have been employed to estimate it. However, these methods are known to be less suitable for exhaust gases with low SO3 concentrations. Therefore, in this study, since the temperature of the exhaust gas is expected to decrease due to the low-load operation of the coal-fired power plant, sulfuric acid condensation and low-temperature corrosion are anticipated. We aimed to conduct a quantitative evaluation to propose ways to prevent damage by limiting operating conditions and improving facilities. The experimental results showed that the corrosion rate increased linearly with rising temperatures at a certain sulfuric acid concentration. Furthermore, variations in sulfuric acid concentrations generated during the current power plant operation process did not significantly affect the dew point, and the dew point of sulfuric acid under these conditions was observed to be between 120 - 130 ℃.

주제어

표/그림 (8)

그림 Fig. 2. Acid leak detection mist (a) and application to the specimen (b)
그림 Fig. 1. Sulfuric acid dew point corrosion chamber
표 Table 1. Chemical compositions and temperature for exhaust gas
표 Table 2. Chemical compositions and mechanical properties for S-Ten2
그림 Fig. 3. Polarization curves for Tafel analysis of S-Ten2 with sulfuric acid concentration and temperature
그림 Fig. 4. Comparison of corrosion rate after Tafel analysis for S-Ten2 with sulfuric acid concentration (unit: mm/year)
그림 Fig. 5. Predictive formula of corrosion rate after Tafel analysis for S-Ten2 with sulfuric acid concentration
그림 Fig. 6. Surface morphologies after dew point experiment for S-Ten2 with sulfuric acid concentration

참고문헌 (19)

H. Zhang and J. Zhuang, Research of Development and？Industrial Application of Heat Pipe Technology in China,？Appled Thermal Engineering, 23, 1067 (2003). Doi:？https://doi.org/10.1016/S1359-4311(03)00037-1

상세보기
X. Q. Cheng, F. L. Sun, S. J. Lv, and X. G. Li, A New？Steel with Good Low-Temperature Sulfuric Acid Dew？Point Corrosion Resistance, Materials and Corrosion, 63,？598 (2012). Doi: https://doi.org/10.1002/maco.201006046

상세보기
Z. Y. Liang and Q. X. Zhao, Failure Analysis of Spiral？Finned Tube on the Economizer, Engineering Failure？Analysis, 28, 208 (2013). Doi: https://doi.org/10.1016/j.engfailanal.2012.10.010

상세보기
J. Zhang, Discriminate and Discuss on Some Mistake？Region and Doubtful Point Where the Gas Acid Dew？Point Calculating Methods had be Studies, Boiler Technology, 44, 10 (2013).
K. Ceng, J. Fan, Z. Chi, and L. Shen, The Prevention？Principle and Calculation of Fouling, Slagging, Wear and？Corrosion of Boiler and Heat Exchanger, Science Press,？381 (1994).
D. Fleig, M. U. Alzueta, F. Normann, M. Abian, K.？Andersson, and F. Johnsson, Measurement and Modeling of Sulfur Trioxide Formation in a Flow Reactor under？Post-Flame Conditions, Combustion and Flame, 160,？1142 (2013). Doi: https://doi.org/10.1016/j.combustflame.2013.02.002

상세보기
T. L. Jorgensen, H. Livbjerg, and P. Glarborg, Homogeneous and Heterogeneously Catalyzed Oxidation of SO2,？Chemical Engineering Science, 62, 4496 (2007). Doi:？https://doi.org/10.1016/j.ces.2007.05.016

상세보기
G. Whittingham, The Corrosive Nature of Combustion？Gases, Anti-Corrosion Methods and Materials, 1, 182？(1954). Doi: https://doi.org/10.1108/eb018949

상세보기
D. R. Holmes, Low-Temperature Corrosion, Institute of？Corrosion Science and technology, Birmingham (1985).
D. Lampert, Low-Temperature Corrosion in Feed-Heaters Heated by Flue Gas, Brown Bover. Rev., 65, 691？(1978).
F. Barreras and J. Barroso, Behavior of a High-Capacity？Steam Boiler using Heavy Fuel Oil Part II: Cold-End？Corrosion, Fuel Processing Technology, 86, 107 (2004).？Doi: https://doi.org/10.1016/j.fuproc.2003.12.005

상세보기
H. Han, Y. L. He, and W. Q. Tao, A Numerical Study of？the Deposition Characteristics of Sulfuric Acid Vapor on？Heat Exchanger Surfaces, Chemical Engineering Science, 101, 620 (2013). Doi: https://doi.org/10.1016/j.ces.2013.07.024

상세보기
Z. M. Li, F. Z. Sun, and Y. T. Shi, Experimental Study？and Mechanism Analysis on Low Temperature Corrosion of Coal Fired Boiler Heating Surface, Applied Thermal Engineering, 80, 355 (2015). Doi: https://doi.org/10.1016/j.applthermaleng.2015.02.003

상세보기
M. Y. Park, J. S. Moon and D. J. Kang, The Corrosion？Inhibition Characteristics of Sodium Nitrite Using an Online Corrosion Rate Measurement System, Corrosion？Science and Technology, 14, 85 (2015). Doi: https://doi.org/10.14773/cst.2015.14.2.85

원문보기 상세보기
J. S. Moon, J. K. Lee, J. B. Lee and P. Y. Park, Study on？an On-line Measurement System of Corrosion Rate by？Linear Polarization Resistance, Corrosion Science and？Technology, 11, 135 (2012). Doi: https://doi.org/10.14773/cst.2012.11.4.135

원문보기 상세보기
Y. G. Kim, S. W. Jung, H. S. Song, S. M. Lee and Y. T.？Kho, Corrosion Rate Measurement Technique with Thin？Film Electric Resistance Sensor, Corrosion Science and？Technology, 1, 315 (2002). https://www.j-cst.org/opensource/pdfjs/web/pdf_viewer.htm?codeC00010400315
M. B. Rockel and R. Bender, Corrosion Handbook, Society for Chemical Engineering and Biotechnology, Frankfurt, Germany (2008).
M. A. Quraishi and S. Khan, Inhibition of Mild Steel？Corrosion in Sulfuric Acid Solution by Thiadiazoles,？Journal of Applied Electrochemistry, 36, 539 (2006).？Doi: https://doi.org/10.1007/s10800-005-9087-6

상세보기
M. Cherif, A. Mgaidi, M. N. Ammar, M. Abderrabba,？and W. Furst, Representation of VLE and Liquid Phase？Composition with an Electrolyte Model, Fluid Phase？Equilibria, 194, 729 (2002). Doi: https://doi.org/10.1016/S0378-3812(01)00688-4

상세보기

내보내기 구분	파일저장 인쇄 메일전송
구성항목	기본정보 상세정보 관리번호, 논문명, 저널/프로시딩명, 저자 , 발행년, 권, 호, 시작페이지, 끝페이지, 발행기관 관리번호, 논문명, 대등논문명, 저자 , 저널/프로시딩명, 발행기관, 발행년, 발행언어, 권, 호, 시작페이지, 끝페이지, ISBN, ISSN, 주제분야, 키워드, 초록(한글), 초록(영문), 저자(소속기관)
저장형식	Text(ASCII format) Excel format RefWorks Direct Export RIS format (for Reference Manager, ProCite, EndNote), Scholar's Aids, Mendeley
메일정보	받는사람 (필수) @ 보내는사람 (선택) @ 제목 내용 KISTI 검색결과 이메일 서비스
안내	총 건의 자료가 검색되었습니다. 다운받으실 자료의 인덱스를 입력하세요. (1-10,000) 검색결과의 순서대로 최대 10,000건 까지 다운로드가 가능합니다. 데이타가 많을 경우 속도가 느려질 수 있습니다.(최대 2~3분 소요) 다운로드 파일은 UTF-8 형태로 저장됩니다. 파일의 내용이 제대로 보이지 않을실 때는 웹브라우저 상단의 보기 -> 인코딩 -> 자동선택 여부를 확인하십시오. ~ Text(ASCII format) Excel format

연합인증