[논문]High-temperature steam oxidation behavior of alumina-forming duplex FeNiCrAl and ferritic FeCrAl alloys at 800 °C to 1050 °C

Kim, Chaewon; Kim, Hyunmyung; Heo, Woong; Jang, Changheui; Lee, Sung Yong; Lee, Seungjae; Lee, Jin-Soo

doi:10.1016/j.corsci.2021.109658

[해외논문] High-temperature steam oxidation behavior of alumina-forming duplex FeNiCrAl and ferritic FeCrAl alloys at 800 °C to 1050 °C

Corrosion science, v.190, 2021년, pp.109658 -

Kim, Chaewon (Korea Advanced Institute of Science and Technology) , Kim, Hyunmyung (Korea Atomic Energy Research Institute) , Heo, Woong (Korea Advanced Institute of Science and Technology) , Jang, Changheui (Korea Advanced Institute of Science and Technology) , Lee, Sung Yong (KEPCO Nuclear Fuel) , Lee, Seungjae (KEPCO Nuclear Fuel) , Lee, Jin-Soo (Korea Institute of Materials Science)

Abstract ▼ AI-Helper

Abstract Two alumina-forming Fe-based alloys, duplex FeNiCrAl (alumina-forming duplex stainless steel, ADSS) and ferritic FeCrAl (APM) alloys, were oxidized in steam at 800 °C to 1050 °C for up to 72 h. Formation of spinel oxides on ADSS resulted in larger weight gain than APM, while the highest weight gain was observed at 900 °C. Outer γ- and/or θ-alumina and inner α-alumina were formed on APM, whereas dispersed spinel oxides as well as γ- and α-alumina on ADSS. Similar alumina formation kinetics was observed for both alloys, while transient alumina formation resulted in faster kinetics at 900 °C. Highlights Two alumina-forming alloys, FeNiCrAl (ADSS) and FeCrAl (APM), were oxidized at 800, 900 and 1050 °C in steam. ADSS showed slightly higher weight gain than APM above 900 °C due to the spinel oxide formation. Two alumina-forming alloys showed highest weight gains at 900 °C. Transient alumina caused the highest weight gain and alumina forming kinetics at 900 °C.

Keyword

참고문헌 (33)

Metall. Trans. E Pint 2 190 2015 Material selection for accident tolerant fuel cladding
J. Nucl. Mater. Yamamoto 467 703 2015 10.1016/j.jnucmat.2015.10.019 Development and property evaluation of nuclear grade wrought FeCrAl fuel cladding for light water reactors

상세보기
Nucl. Eng. Technol. Kim 48 1 1 2016 10.1016/j.net.2015.11.011 Development of status of accident-tolerant fuel for light water reactors in Korea

원문보기 상세보기
Nucl. Eng. Des. Duan 316 131 2017 10.1016/j.nucengdes.2017.02.031 Current status of materials development of nuclear fuel cladding tubes for light water reactors

상세보기
Corros. Sci. Park 94 459 2015 10.1016/j.corsci.2015.02.027 A study of the oxidation of FeCrAl alloy in pressurized water and high-temperature steam environment

상세보기
J. Nucl. Mater. Terrani 479 36 2016 10.1016/j.jnucmat.2016.06.047 Uniform corrosion of FeCrAl alloys in LWR coolant environments

상세보기
J. Nucl. Mater. Pint 440 1-3 420 2013 10.1016/j.jnucmat.2013.05.047 High temperature oxidation of fuel cladding candidate materials in steam-hydrogen environments

상세보기
Mater. Sci. Eng. A Sun 700 554 2017 10.1016/j.msea.2017.06.036 Processability evaluation of a Mo-containing FeCrAl alloy for seamless thin-wall tube fabrication

상세보기
Mater. Sci. Eng. A Aghamiri 771 2020 10.1016/j.msea.2019.138636 Microstucture and texture evolution and ring-tensile properties of recrystallized FeCrAl ODS cladding tubes

상세보기
J. Nucl. Mater. Kim 507 1 2018 10.1016/j.jnucmat.2018.04.027 Development of alumina-forming duplex stainless steels as accident-tolerant fuel cladding materials for light water reactors

상세보기
Int. J. Energy Res. Kim 2019 Feasibility assessment of the alumina-forming duplex stainless steels as accident tolerant fuel cladding materials for light water reactors
J. Nucl. Mater. Tang 551 496 2018 10.1016/j.jnucmat.2018.09.026 Influence of composition and heating schedules on compatibility of FeCrAl alloys with high-temperature steam

상세보기
J. Nucl. Mater. Maeda 516 317 2019 10.1016/j.jnucmat.2019.01.041 Effect of zirconium and oxygen on the oxidation of FeCrAl-ODS alloys under air and steam conditions up to 1500 °C

상세보기
J. Nucl. Mater. Stuckert 534 2020 10.1016/j.jnucmat.2020.152143 Results of the QUENCH-LOCA experimental program at KIT

상세보기
Pasamehmetoglu 2018 State-of the-ATF Report on Light Water Reactor Accident-Tolerant Fuels. No. NEA-7317
J. Electrochem. Soc. Gulbrasen 106 4 294 1959 10.1149/1.2427333 Oxidation studies on the iron-chromium-aluminum heater alloys

상세보기
Mater. High Temp. Pedraza 22 3-4 545 2005 10.1179/mht.2005.065 TEM analysis of the growth of oxide scales at different temperature in FeAl grade 3 intermetallic alloy

상세보기
Corros. Sci. Li 157 274 2019 10.1016/j.corsci.2019.05.029 Intermediate temperature corrosion behavior of Fe-12Cr-6Al-2Mo-0.2Si-0.03Y alloy (C26M) at 300-600 °C

상세보기
JOM Rebak 70 1484 2018 10.1007/s11837-018-2979-9 Oxidation characteristics of two FeCrAl alloys in air and steam from 800 °C to 1300 °C

상세보기
Mater. Sci. Eng. A Kim 743 159 2019 10.1016/j.msea.2018.11.084 400 °C aging embrittlement of FeCrAl alloys: microstructure and fracture behavior

상세보기
J. Nucl. Mater. Kim 441 612 2013 10.1016/j.jnucmat.2013.04.023 Corrosion characteristics of Ni-base superalloys in high temperature steam with and without hydrogen

상세보기
Oxid. Met. Kadiri 64 63 2005 10.1007/s11085-005-5715-0 Abnormal high growth rates of metastable aluminas on FeCrAl alloys

상세보기
Corros. Sci. Liu 50 8 2272 2008 10.1016/j.corsci.2008.05.019 Early stages of the oxidation of a FeCrAlRe alloy (Kanthal AF) at 900 °C: a detailed microstructural investigation

상세보기
Arch. Metall. Mater. Reszka 59 1 77 2014 10.2478/amm-2014-0013 Characterization of alumina scale formed on FeCrAl steel

상세보기
Corros. Sci. Zhang 159 2019 10.1016/j.corsci.2019.108137 Oxidation behaviors of Fe-25Cr-20Ni-xNb austenite weld metals at 1100 °C in ambient air:role of elemental niobium

상세보기
Corros. Sci. Chen 145 90 2018 10.1016/j.corsci.2018.09.016 Oxidation behaviors of Fe-20Cr-25Ni-Nb austenitic stainless steel in high-temperature environment with small amount of water vapor

상세보기
Defect Diffus. Forum Bergner 95-98 709 1993 10.4028/www.scientific.net/DDF.95-98.709 Impurity and chemical diffusion of Al in BCC and FCC iron

상세보기
Acta Mater. Chen 159 150 2018 10.1016/j.actamat.2018.08.018 Effect of microstructure on early oxidation of MCrAlY coatings

상세보기
Oxid. Met. Lobnig 37 81 1992 10.1007/BF00665632 Diffusion of cations in chromia layers grown on iron-base alloys

상세보기
J. Am. Ceram. Soc. Levin 81 8 1995 1998 10.1111/j.1151-2916.1998.tb02581.x Metastable alumina polymorphs: crystal structures and transition sequences

상세보기
Oxid. Met. Kitajima 73 375 2010 10.1007/s11085-009-9184-8 Rapid formation of α-Al2O3 scale on an Fe-Al alloy by pure-metal coatings at 900 °C

상세보기
Appl. Surf. Sci. Kaplin 301 258 2014 10.1016/j.apsusc.2014.02.056 The effect of grain size on the oxidation of NiCoCrAlY

상세보기
Oxid. Met. Chegroune 70 331 2008 10.1007/s11085-008-9126-x On the competitive growth of alpha and transient aluminas during the first stages of thermal oxidation of FeCrAl alloys at intermediate temperatures

상세보기

LOADING...

활용도 분석정보

상세보기

다운로드

내보내기

활용도 Top5 논문

해당 논문의 주제분야에서 활용도가 높은 상위 5개 콘텐츠를 보여줍니다.
더보기 버튼을 클릭하시면 더 많은 관련자료를 살펴볼 수 있습니다.

원문 URL 링크

DOI : 10.1016/j.corsci.2021.109658
Elsevier : 저널 > 논문

*원문 PDF 파일 및 링크정보가 존재하지 않을 경우 KISTI DDS 시스템에서 제공하는 원문복사서비스를 사용할 수 있습니다.

저작권 관리 안내

내보내기 메뉴

내보내기 구분

파일저장
인쇄
메일전송

구성항목

기본정보
상세정보

관리번호, 논문명, 저널/프로시딩명, 저자 , 발행년, 권, 호, 시작페이지, 끝페이지, 발행기관

저장형식

Text(ASCII format)
Excel format
RefWorks Direct Export
RIS format (for Reference Manager, ProCite, EndNote), Scholar's Aids, Mendeley

메일정보

받는사람 (필수): @
보내는사람 (선택): @
제목
내용: KISTI 검색결과 이메일 서비스

안내

총 건의 자료가 검색되었습니다.

다운받으실 자료의 인덱스를 입력하세요. (1-10,000)

검색결과의 순서대로 최대 10,000건 까지 다운로드가 가능합니다.

데이타가 많을 경우 속도가 느려질 수 있습니다.(최대 2~3분 소요)

다운로드 파일은 UTF-8 형태로 저장됩니다.
파일의 내용이 제대로 보이지 않을실 때는 웹브라우저 상단의 보기 -> 인코딩 -> 자동선택 여부를 확인하십시오.

Text(ASCII format)
Excel format

표제어: PCR

동의어: Packet Collision Rate

용어 설명 출처 목록 (6)

용어 설명: PCR은 세균 특이성이 있는 primer를 이용하여 적은 수의 세균이 있을지라도 쉽게 검출할 수 있는 유용한 방법이며, 이를 이용하여 구강 내 치면세균막이나 타액에서 직접 세균을 검출할 수 있게 되었다[8].

AI-Helper ※ AI-Helper는 을 사용합니다.

AI-Helper

안녕하세요, AI-Helper입니다. 좌측 "선택된 텍스트"에서 텍스트를 선택하여 요약, 번역, 용어설명을 실행하세요.
※ AI-Helper는 부적절한 답변을 할 수 있습니다.

연합인증