초록 ▼

A hinged lid or flip top cigarette pack includes an inwardly stepped or offset collar 29 abutting the top areas of the pack front and side walls. The collar is only joined to the pack by narrow Z-folded residual connections 30, 31 at the opposite ends of the collar front wall 32, the remaining porti

A hinged lid or flip top cigarette pack includes an inwardly stepped or offset collar 29 abutting the top areas of the pack front and side walls. The collar is only joined to the pack by narrow Z-folded residual connections 30, 31 at the opposite ends of the collar front wall 32, the remaining portions being severed by cut lines 36 and 40-42 which define an intermediate reinforcing strip 44. This strip is folded in against the front wall of the pack along a weakened fold line to define a rounded upper pack edge 46, which overlaps with the lower edge of the collar front wall along a narrow zone 47.

대표청구항 ▼

A hinge-lid cigarette pack folded from a unitary blank and including a lid hinged to a rear wall of the pack, the lid surrounding and engaging in its closed position an upstanding collar inwardly set back from a front and opposite side walls of the pack, characterized by: (a) the collar being direct

A hinge-lid cigarette pack folded from a unitary blank and including a lid hinged to a rear wall of the pack, the lid surrounding and engaging in its closed position an upstanding collar inwardly set back from a front and opposite side walls of the pack, characterized by: (a) the collar being directly connected to the blank only by a pair of narrow residual connecting bridges (30, 31) disposed at opposite ends of a front wall (32) of the collar and extending to corresponding opposite ends of the upper edge of the front wall (10) of the pack, (b) an elongated intermediate reinforcing strip (44) disposed in the open blank between the upper edge of the front wall of the pack and a lower edge of the collar front wall and defined by a transverse separating cut (40) extending between and above the connecting bridges and a pair of angled perforation cuts (42) individually extending from opposite ends of the separating cut to transverse fold lines (45) on the bridges, (c) the height of each perforation cut measured transverse to the length of the intermediate reinforcing strip being less than the width of the strip, and (d) the collar and intermediate reinforcing strip being Z-folded inwardly about the upper edge of the front wall of the pack and the transverse fold lines, with the strip lying against the inner surface of the upper front wall portion of the pack and engaging the lower edge of the collar front wall.