[논문]Power quality improvements of arc welding power supplies by modified bridgeless SEPIC PFC converter

Bouafassa, Amar; Fernandez-Ramirez, Luis M.; Babes, Badreddine

doi:10.1007/s43236-020-00143-2

Power quality improvements of arc welding power supplies by modified bridgeless SEPIC PFC converter

Journal of power electronics, v.20 no.6, 2020년, pp.1445 - 1455

Bouafassa, Amar (Department of Electronics, Electrical Engineering and Automation, National Polytechnic School of Constantine) , Fernandez-Ramirez, Luis M. (Research Group in Sustainable and Renewable Electrical Technologies, Department of Electrical Engineering, Higher Polytechnic School of Algeciras, University of Cadiz) , Babes, Badreddine (Research Center in Industrial Technologies (CRTI))

Abstract ▼ AI-Helper

This paper proposes an efficient bridgeless power factor corrected (PFC) modified single ended primary inductor converter (SEPIC) for arc welding power supplies (AWPS). The overall configuration is composed of two converters: (1) a modified bridgeless SEPIC PFC converter, which is controlled by a PI controller to achieve a high power factor and fast response; and (2) a full bridge buck converter with high-frequency transformer for high-frequency isolation to ensure arc welding stability. The proposed system is simulated under different operating conditions of an AWPS. It is also tested in real time by a hardware-in-the-loop system based on a dSPACE DS1103 control board. The system performances are evaluated based on power quality indices such as power factor, total harmonic distortions of the AC grid current, and voltage regulation. The obtained results show that the proposed controller enhances the weld bead quality by keeping a constant current at the output and a stable arc, meet the international power quality standards and robustness for voltage regulation.

주제어

참고문헌 (14)

Narula, S., Singh, B., Bhuvaneshwari, G.: Interleaved CSC converter-based power factor corrected switched mode power supply for arc welding. IET Power Electron. 9(12), 2404-2415 (2016)

상세보기
Narula, S., Singh, B., Bhuvaneswari, G., Pandey, R.: Improved power quality bridgeless converter-based SMPS for arc welding. IEEE Trans. Ind. Electron. 64(1), 275-284 (2017)

상세보기
Dugan, R.C., McGranaghan, M.F., Santoso, S., Wayne Beaty, H.: Electrical power system quality, 2nd edn. McGraw-Hill, USA (2003)
Narula, S., Singh, B., Bhuvaneswari, G.: Power factor corrected welding power supply using modified zeta converter. IEEE Trans. Emerg. Sel. Topics Power Electron. 4(2), 617-625 (2016)
Narula, S., Singh, B., Bhuvaneswari, G.: Improved power quality based welding power supply with over current handling capability. IEEE Trans. Power Electron. 31(4), 2850-2859 (2016)

상세보기
Madhulingam, T., Subbaiyan, T., Shanmugam, P., Kannan, S.: Design and development of improved power quality based microbutt welding power supply. IET Power Electron. 10(7), 746-755 (2017)

상세보기
Lee, S.W., Do, H.L.: Efficient bridgeless PFC converter with reduced voltage stress. Int. J. Circuit Theory Appl. 44(7), 1455-1467 (2016)

상세보기
Liu, Y., Sun, Y., Su, M.: A control method for bridgeless Cuk/SEPIC PFC rectifier to achieve power decoupling. IEEE Trans. Ind. Electron. 64(9), 7272-7276 (2017)

상세보기
Shen, C.L., Yang, S.H.: Dual-output single-stage bridgeless SEPIC with power factor correction. J. Power Electron. 15(2), 309-318 (2015)

원문보기 상세보기
Mahdavi, M., Farzanehfardn, H.: Zero-voltage transition bridgeless single-ended primary inductance converter power factor correction rectifier. IET Power Electron. 7(4), 895-902 (2014)

상세보기
Kommukuri, V.S., Mohanty, K.B.: Modified bridgeless SEPIC rectifier for power factor correction with reduced switch stress operating in continuous conduction mode. J. Circ. Syst. Comput. 27(8), 185012 (2018)
Singh, B., Kushwaha, R.: A PFC based EV battery charger using a bridgeless isolated SEPIC converter. IEEE Trans. Ind Appl. 56(1), 477-487 (2020)

상세보기
RomaiNoor, M.K., et al.: Modified single-switch bridgeless PFC SEPIC structure by eliminating circulating current and power quality improvement. IET Power Electron. 12(14), 3792-3801 (2019)

상세보기
Yang, J., Do, H.: Bridgeless SEPIC converter with a ripple-free input current. IEEE Trans. Power Electron. 28(7), 3388-3394 (2013)

상세보기

내보내기 구분	파일저장 인쇄 메일전송
구성항목	기본정보 상세정보 관리번호, 논문명, 저널/프로시딩명, 저자 , 발행년, 권, 호, 시작페이지, 끝페이지, 발행기관 관리번호, 논문명, 대등논문명, 저자 , 저널/프로시딩명, 발행기관, 발행년, 발행언어, 권, 호, 시작페이지, 끝페이지, ISBN, ISSN, 주제분야, 키워드, 초록(한글), 초록(영문), 저자(소속기관)
저장형식	Text(ASCII format) Excel format RefWorks Direct Export RIS format (for Reference Manager, ProCite, EndNote), Scholar's Aids, Mendeley
메일정보	받는사람 (필수) @ 보내는사람 (선택) @ 제목 내용 KISTI 검색결과 이메일 서비스
안내	총 건의 자료가 검색되었습니다. 다운받으실 자료의 인덱스를 입력하세요. (1-10,000) 검색결과의 순서대로 최대 10,000건 까지 다운로드가 가능합니다. 데이타가 많을 경우 속도가 느려질 수 있습니다.(최대 2~3분 소요) 다운로드 파일은 UTF-8 형태로 저장됩니다. 파일의 내용이 제대로 보이지 않을실 때는 웹브라우저 상단의 보기 -> 인코딩 -> 자동선택 여부를 확인하십시오. ~ Text(ASCII format) Excel format

연합인증

Power quality improvements of arc welding power supplies by modified bridgeless SEPIC PFC converter

Abstract ▼ AI-Helper

주제어

참고문헌 (14)

이 논문을 인용한 문헌

관련 콘텐츠

원문 URL 링크

이 논문과 함께 이용한 콘텐츠

AI-Helper ※ AI-Helper는 오픈소스 모델을 사용합니다.

선택된 텍스트