화열(火熱)이 에폭시수지로 보수·보강된 콘크리트 구조체의 내구성에 미치는 영향에 관한 연구 A Study on the Effect of Fire Heat on the Durability of Concrete Structures Repaired and Reinforced with Epoxy Resin원문보기
연구목적: 건축물의 노후화에 따른 보수, 보강 건축물의 증가에 따라 기 보강된 건축물에 화재가 발생시 화재 후 구조물에 미치는 영향성을 분석하여 보수, 보강대책의 기준을 마련하고자 한다. 연구방법: 콘크리트 배합설계에 의한 공시체를 제작하여 28일 양생 후 압축기를 통해 압축강도 측정 및 파괴를 유도후 에폭시로 보수, 보강하여 3일 양생 후 일부공시체를 재 압축강도시험을 실시하여 강도 복원 정도를 파악하고 보수, 보강한 나머지와 보수, 보강하지 않은 공시체를 실험용 전기로에 넣고 시간, 온도별로 가열한 후 압축강도를 실험하여 화재의 영향성을 추정함. 연구결과: 항복된 공시체를 에폭시로 보강한 후 실험용전기로에 넣어 가열을 시간별로 온도의 차이를 주어 실험한 결과 높은 온도에서 열 영향을 받는 시간이 길면 길수록 강도의 저하가 발생함을 알 수 있었고 보수, 보강되지 않은 공시체보다 더 강도 저하가 있음을 알 수 있었다. 결론: 이를 토대로 볼 때 에폭시 수지로 보수, 보강된 건축물이 화해를 입을 때는 일반 보수되지 않은 건축물보다 더 위험함을 알 수 있었으므로 화재에 대한 안정성을 고려하였을 때 보수보강 표면에 내화피복재 등을 도포하는 등 화재 취약에 대비하여야하겠다.
연구목적: 건축물의 노후화에 따른 보수, 보강 건축물의 증가에 따라 기 보강된 건축물에 화재가 발생시 화재 후 구조물에 미치는 영향성을 분석하여 보수, 보강대책의 기준을 마련하고자 한다. 연구방법: 콘크리트 배합설계에 의한 공시체를 제작하여 28일 양생 후 압축기를 통해 압축강도 측정 및 파괴를 유도후 에폭시로 보수, 보강하여 3일 양생 후 일부공시체를 재 압축강도시험을 실시하여 강도 복원 정도를 파악하고 보수, 보강한 나머지와 보수, 보강하지 않은 공시체를 실험용 전기로에 넣고 시간, 온도별로 가열한 후 압축강도를 실험하여 화재의 영향성을 추정함. 연구결과: 항복된 공시체를 에폭시로 보강한 후 실험용전기로에 넣어 가열을 시간별로 온도의 차이를 주어 실험한 결과 높은 온도에서 열 영향을 받는 시간이 길면 길수록 강도의 저하가 발생함을 알 수 있었고 보수, 보강되지 않은 공시체보다 더 강도 저하가 있음을 알 수 있었다. 결론: 이를 토대로 볼 때 에폭시 수지로 보수, 보강된 건축물이 화해를 입을 때는 일반 보수되지 않은 건축물보다 더 위험함을 알 수 있었으므로 화재에 대한 안정성을 고려하였을 때 보수보강 표면에 내화피복재 등을 도포하는 등 화재 취약에 대비하여야하겠다.
Purpose: In accordance with the increase in the number of buildings repaired and reinforced following deterioration from when a fire occurs in a previously reinforced building, the impact on the structure after the fire is analyzed to establish standards for repair and reinforcement measures. Method...
Purpose: In accordance with the increase in the number of buildings repaired and reinforced following deterioration from when a fire occurs in a previously reinforced building, the impact on the structure after the fire is analyzed to establish standards for repair and reinforcement measures. Method: After curing for 28 days, the process was to measure the compressive strength and induce destruction through a compressor, repair and reinforce it with epoxy, and conduct a re-compressive strength test on some specimens after curing for 3 days to understand the degree of strength restoration. The rest of the repaired and reinforced specimens as well as the unrepaired and unreinforced specimens were then put into an oven and heated according to the temporal and temperate conditions listed below, and then the compressive strength was tested to estimate the impact of fire. Result: After reinforcing the yielded specimen with epoxy, the process was to then put it in an oven and heat it at different temperatures over time. It was found that there was a decrease in the strength of the reinforcement more than that of the actual specimen. Conclusion: Based on this, it was found that a building repaired and reinforced with epoxy resin is actually more dangerous than a general unrepaired building when it is damaged by fire, and thus, that it must be prepared for fire vulnerabilities.
Purpose: In accordance with the increase in the number of buildings repaired and reinforced following deterioration from when a fire occurs in a previously reinforced building, the impact on the structure after the fire is analyzed to establish standards for repair and reinforcement measures. Method: After curing for 28 days, the process was to measure the compressive strength and induce destruction through a compressor, repair and reinforce it with epoxy, and conduct a re-compressive strength test on some specimens after curing for 3 days to understand the degree of strength restoration. The rest of the repaired and reinforced specimens as well as the unrepaired and unreinforced specimens were then put into an oven and heated according to the temporal and temperate conditions listed below, and then the compressive strength was tested to estimate the impact of fire. Result: After reinforcing the yielded specimen with epoxy, the process was to then put it in an oven and heat it at different temperatures over time. It was found that there was a decrease in the strength of the reinforcement more than that of the actual specimen. Conclusion: Based on this, it was found that a building repaired and reinforced with epoxy resin is actually more dangerous than a general unrepaired building when it is damaged by fire, and thus, that it must be prepared for fire vulnerabilities.
만약 에폭시로 보수, 보강된 건축물에 화재가 발생할 경우 주요구조부에 어떠한 영향을 미치는지를 실험을 통해 확인하고 화재 이후 건축물의 상태를 예측하고 건축물의 안전을 고려하여 반드시 보다 체계적인 안전점검을 실시하여 안전한 상태의 건축물이 되도록 보강하여야 한다는 필요성을 인식시키고 최초 보수, 보강시 만일의 화재에 대비하여 보강부위에 내화피복등을 고려해야 한다는 당위성을 정착 시키도록 실질적인 데이터를 마련하는 연구의 목적으로, 학술적 가치가 있는 논문입니다.
본 논문은 에폭시 수지로 보수, 보강된 콘크리트 구조물에 화재가 발생하여 주요 구조부에 화해를 입었을 시 화재 온도별로 어떠한 피해를 입게 되는지를 살펴보는 실험에 그 주안점이 있다.
제안 방법
기 실험한 공시체를 자동저압주입공법으로 에폭시 난연수지와 일반 초저점도에폭시수지로 균열에 실링작업후 그라우팅보수, 보강(Lee, 2000; Park, 1992; Cho, 1997)하여 양생후 100℃와 500℃에서 각각 30분 동안 가열 상태를 지속시켜 실제 화해 입었을 때와 유사한 상황에서 콘크리트의 압축강도의 변화를 보수, 보강하지 않은 원공시체를 동일한 가열 상태로 두었을 때와 비교하여 보았다.
현장에서 공시체 몰드에 상기 현장 배합표에 의거 만든 레미콘을 3층으로 나누어 각층을 25회 다짐하여 공시체를 제작 후 다음날 응결이 완전히 이루어진 후 수온 20℃를 유지하는 실험실 수조로 옮겨 28일 동안 양생한 후 꺼내 7일간 상온(약20℃)에서 추가 건조 양생(실험기간을 고려하면 35일~42일 양생)하여 실제 건축물과 비슷한 습도를 가진 공시체 상태를 만든 후 압축강도시험(KS F 2405)을 진행하였다.
대상 데이터
Table 1의 실험한 공시체를 자동저압주입공법으로 에폭시난연수지(25℃에서 점도 500~700 cps)와 일반 초저점도에폭시수지(25℃에서 점도 70~100 cps 이하)로 균열에 실링작업 후 그라우팅 보수, 보강하여 양생 후 콘크리트의 압축강도의 변화를 보수, 보강하지 않았을 때와 비교하여 얼마나 강도가 복원되는지를 검토하여 보았고 이 실험에서 사용한 에폭시수지는 시중에 유통되는 D사제품으로 초점도일반(D-2001M)과 저점도 난연수지(DYN-1100)를 사용하였다. 그 결과는 Table 2와 같다.
이론/모형
KS F 2405 한국산업표준에 의거 하여 실시하였고 본 실험에 사용한 공시체는 KS F 2403에 의거 제작 되었다.
참고문헌 (11)
Cho, T.K. (1997). A Study on the Repair and Strengthening Effects of Epoxy Grout for the Damaged Concrete?Structure. Master Thesis, Hanyang University Graduate School of Industry.
Hong, K.M., Ha, J.A., Kim, J.H. (2022). "Development of evaluation indicators for the efficient operation and?management of traffic safety facilities." Journal of the Society of Disaster Information, Vol. 18, No. 1, pp. 29-37.
Kim, H.K., Hwang, H.S., Kim, H.M., Choi, D.C., Lee, D.H. (2022). "A numerical analysis study on the influence of?the fire protection system on evacuation safety in apartment houses." Journal of the Society of Disaster Information,?Vol. 18, No. 1, pp. 38-50.
Lee, H.-R. (2000). A Study on Crack Repair Effect of Concrete Beam Using Epoxy Resin. Master Thesis,?Department of Civil Engineering, Honam University.
Lee, S.-H., Min, S.-H. (2020). "Multi-dense facility: Derive of fire occurrence scenarios through fire statistics?analysis." Journal of The Korean Society of Disaster Information, Academic Conference, pp. 47-48.
Lee, Y.-H., Bae, S.-J., Jung, W., Cho, J.-Y., Hong, S.-H., Nam, W.-S., Kim, Y.-M., Kim, J.-Y. (2020). "Performance evaluation method for facility inspection and diagnostic technologies." Journal of The Korean Society of?Disaster Information, Vol. 16, No. 1, pp. 178-191.
Na, Y.H., Park, M.Y., Cho, D.Y. (2022). "A study of port facility maintenance and decision-making support system?development." Journal of the Society of Disaster Information, Vol. 18, No. 2, pp. 290-305.
Ngan, L.-P. (2005). The Role of Growth Hormone Secretagogue Receptor (GHSR) in apoptosis. The Chinese?University of Hong Kong, Hong Kong.
Park, G.-Y. (1992). A Study on the Crack Behavior in Concrete Structures. Master Thesis, Konkuk University?Graduate School of Industry.
Park, S.-Y. (2022). A Study on How to Lower the Grounding Impedance by Needles-typed Grounding Rods. Ph.D.?Dissertation, Department of Industrial Engineering, Sunmoon University.
Ryu, S.-R. (2022). "A study on the flooding risk assessment of energy storage facilities according to climate?change." Journal of the Society of Disaster Information, Vol. 18, No. 1, pp. 10-18.
※ AI-Helper는 부적절한 답변을 할 수 있습니다.