$\require{mediawiki-texvc}$

연합인증

연합인증 가입 기관의 연구자들은 소속기관의 인증정보(ID와 암호)를 이용해 다른 대학, 연구기관, 서비스 공급자의 다양한 온라인 자원과 연구 데이터를 이용할 수 있습니다.

이는 여행자가 자국에서 발행 받은 여권으로 세계 각국을 자유롭게 여행할 수 있는 것과 같습니다.

연합인증으로 이용이 가능한 서비스는 NTIS, DataON, Edison, Kafe, Webinar 등이 있습니다.

한번의 인증절차만으로 연합인증 가입 서비스에 추가 로그인 없이 이용이 가능합니다.

다만, 연합인증을 위해서는 최초 1회만 인증 절차가 필요합니다. (회원이 아닐 경우 회원 가입이 필요합니다.)

연합인증 절차는 다음과 같습니다.

최초이용시에는
ScienceON에 로그인 → 연합인증 서비스 접속 → 로그인 (본인 확인 또는 회원가입) → 서비스 이용

그 이후에는
ScienceON 로그인 → 연합인증 서비스 접속 → 서비스 이용

연합인증을 활용하시면 KISTI가 제공하는 다양한 서비스를 편리하게 이용하실 수 있습니다.

Abstract AI-Helper 아이콘AI-Helper

Recently, the cross flow turbines attract more attention for their good performance over a large operating regime at off design point. This study employs a very low head cross flow turbine, which has open inlet duct and has barely been studied before, to investigate the performance of the cross flow...

주제어

AI 본문요약
AI-Helper 아이콘 AI-Helper

* AI 자동 식별 결과로 적합하지 않은 문장이 있을 수 있으니, 이용에 유의하시기 바랍니다.

제안 방법

  • This study tries to employ an air suction pipe behind the rear part of the runner. The purpose of this study is not only to investigate the effect of air layer for a 1.5m head of cross flow turbine which is barely studied before, but also to verify the effectiveness of air layer formation in the runner passage. Two-phase flow transient analysis is conducted under the condition of gravity to embody the air-layer effect.
  • (6), Durgin(7) and Costa Pereira(8). The works included details concerning the influence of the number of blades, outside diameter of the runner and admission arc of the nozzle on the turbine efficiency, which offers a guideline for the turbine design. However, in this study, as this turbine has a very low head of below 1.

이론/모형

  • This study employs a commercial CFD code of ANSYS CFX(10) to conduct CFD analysis. Two-dimensional CFD analysis is applied to shorten the calculating time and reduce the computational cost, which means that the transverse flow along the thickness direction is not considered in this study.
본문요약 정보가 도움이 되었나요?

참고문헌 (13)

  1. Haimerl, L. A., 1960, The Cross-Flow Turbine, Water Power Engineering Magazine. 

  2. Andrade, J. D., Curiel, C., Kenyery, F., Aguillon, O., Vasquez, A., and Asuaje, M., 2011, "Numerical Investigation of the Internal Flow in a Banki Turbine," International Journal of Rotating Machinery, Vol. 2011, pp. 1-12. 

  3. Mockmore. C. A. and Merryfield, F., 1949, "The Banki Water Turbine," Bulletin Series, No. 25. 

  4. Chandran, A. T., Anil, G. and Chandapillai, J., 2010, "Development and Testing of a Cross Flow Turbine," International Group for Hydraulic Efficiency Measurement. 

  5. Nasir, B. A., 2013, "Design of High Efficiency Cross-Flow Turbine for Hydro-Power Plant," International Journal of Engineering and Advanced Technology, Vol. 2, No. 3, pp. 308-311. 

  6. Khosrowpanah, S., Fiuzat, A. and Albertson, M., 1988, "Experimental Study of Cross-Flow Turbine," Journal of Hydraulic Engineering, Vol. 114, No. 3, pp. 299-314. 

  7. Durgin, W. W. and Fay, W. K., 1984, "Some Fluid Flow Characteristics of a Cross Flow Type Hydraulic Turbine," Small Hydro Power Machinery. 

  8. Costa Pereira, N. H. and Borges, J. E., 1996, "Study of the Nozzle Flow in a Cross-Flow Turbine," International Journal of Mechanical Sciences, Vol. 38, No. 3, pp. 283-302. 

  9. Choi, Y. D., Shin, B. R. and Lee, Y. H., 2010, "Air Layer Effect on the Performance Improvement of a Cross-Flow Hydro Turbine," Journal of Fluid Machinery, Vol. 13, No. 4, pp. 37-43. 

  10. ANSYS Inc., ANSYS CFX Documentation,ver. 13, 2012, http://www.ansys.com. 

  11. Ariff, M., Salim, S. M. and Cheah, S. C., 2009, "Wall Y+ Approach for Dealing with Turbulent Flow Over a Surface Mounted Cube: Part 1 . Low Reynolds Number," Proceeding of Seventh International Conference on CFD in the Minerals and Process Industries, CSIRO, Melbourne, Australia. 

  12. Ariff, M., Salim, S. M. and Cheah, S. C., 2009, "Wall Y+ Approach for Dealing with Turbulent Flow Over a Surface Mounted Cube: Part 2 . High Reynolds Number," Proceeding of Seventh International Conference on CFD in the Minerals and Process Industries, CSIRO, Melbourne, Australia. 

  13. Verhaart, P., 1983, Blade Calculations for Water Turbines of the Banki Type, Eindhoven University of Technology. 

저자의 다른 논문 :

관련 콘텐츠

저작권 관리 안내
섹션별 컨텐츠 바로가기

AI-Helper ※ AI-Helper는 오픈소스 모델을 사용합니다.

AI-Helper 아이콘
AI-Helper
안녕하세요, AI-Helper입니다. 좌측 "선택된 텍스트"에서 텍스트를 선택하여 요약, 번역, 용어설명을 실행하세요.
※ AI-Helper는 부적절한 답변을 할 수 있습니다.

선택된 텍스트

맨위로